Simple explanation of "Tell Target"

[Stephen J. Pintauro]

Hello all,

I guess I am just a bit slow in these matters, but I am having

difficulty understanding exactly what "tell target" does.  I have been

using Flash 2 since it first came out, and I am quite comfortable with

all of its features.  I recently upgraded to Flash 3 and enjoy many of

the new features, including transparancy, mask etc..  I am sure I would

be able to take great advantage of "tell target", if I only had a good

sense of when to use it.  I have read the documentation with the Flash 3

manual, but did not find it particularly helpful.  I assume that the new

Flash 3 Web Animation book due out in August will do a much better job

of explaining this, however I would like to experiment with it sooner.


Would anybody out there be able to offer a layperson's explanation of

"tell target", and perhaps some examples of when it can be used most

effectively?


Thanks in advance,

Stephen Pintauro


--

*****************************

Stephen J. Pintauro, Ph.D.

Associate Professor

Department of Nutritional Sciences

University of Vermont

Phone: 802-656-0541

http://nutrition.uvm.edu/nusc/




------------------------------------------------------------------------

To UNSUBSCRIBE send: unsubscribe flasher in the body of an

email to

list-managershocker [dot] com

.  Problems to:

ownershocker [dot] com

N.B. Email address must be the same as the one you used to subscribe.

For info on digest mode send: info flasher to

list-managershocker [dot] com