Flasher Archive

[Previous] [Next] - [Index] [Thread Index] - [Previous in Thread] [Next in Thread]


Subject: Re: FLASH: zero is not a hundred, hmmm
From: Collin van Ginkel
Date: Wed, 4 Aug 1999 15:40:37 +0100

If I remove the 'OR', everything goes alright. Strange.....


>Hi all,
>
>Playing around a bit in Flash4 I have a ball that bounces of the walls (no
>gravity or anything else yet) But it bounces off at X-co 100 in stead of
>X-co 0 as I programmed it.
>------ code ------
>
>If ((/ball:_x gt 400) OR (/ball:_x lt 0))
> Set Variable: x_speed = - x_speed
>end If
>
>/ball:_x = /ball:_x + x_speed
>
>------ end ------
>
>Any ideas why this won;t work?
>
>Greetz
>
>Collin
>
>
>
>
>
>------------------------------------------------------------------------
>To UNSUBSCRIBE send: unsubscribe flasher in the body of an
>email to list-manageratshocker [dot] com. Problems to: owneratshocker [dot] com
>N.B. Email address must be the same as the one you used to subscribe.
>For info on digest mode send: info flasher to list-manageratshocker [dot] com
>
>


------------------------------------------------------------------------
To UNSUBSCRIBE send: unsubscribe flasher in the body of an
email to list-manageratshocker [dot] com. Problems to: owneratshocker [dot] com
N.B. Email address must be the same as the one you used to subscribe.
For info on digest mode send: info flasher to list-manageratshocker [dot] com

[Previous] [Next] - [Index] [Thread Index] - [Next in Thread] [Previous in Thread]