Re: FLASH: Netscape Browser hijinx!

[Byron Canfield]

Change the value for the Quality paramater from "AutoHigh" to "High" (in

both places).


At 11:29 PM 1/26/99 -0700, you wrote:

>Ok... one last question for the night.  This one might be a stumper... As

>I'm building this photographers site I keep checking it in Internet

>Exploder.  Everything looks fine.  I'm running in 1024 x 768 mode... which

>is the same size my movie is being optimized for.  Actually my screen size

>is 984 width by 582 height.  I chose that size because it was the MAXIMUM

>size without scrollbars I could get in Exploder 4.07.   EVERYTHING was going

>fine UNTIL I took a peak at it in Netscape 4.  As the movie runs you can see

>the bitmaps and vectors shift around just a bit..... then when all the

>movement stops everything shifts a pixel or two back again.  The strange

>thing is.... this doesn't necessarily happen the first time the movie is

>viewed, but deffinitely happens every time therafter.  Ok.... so I'm trying

>to figure out what the prob is and so I change my monitor's resolution to

>800 X 600.  This screwy effect NEVER happens in 800x600. (at least so far)

>

>My theory...

>I have my movie set to run in 100 percent of the browser window and Flash is

>trying to size and align the objects to match each other.

>

>My sollution...

>HECK.... I'm not even sure if my theory is right.... However....  Is there

>an ideal height and width to make FLASH movies?  Is there a setting to force

>objects to sit still with no tiny shifts?  Is there something I should be

>setting in Aftershock?

>

>An example of what I'm talking about can be seen at

>www.websitepartners.com/rapfoto

>Just click the "Twisted" link and you'll see what I'm saying if you're in

>Netscape.  If it doesn't happen the first time just reload.

>

>Thanks a ton,

>

>Al Rosetti

>

>

>

>------------------------------------------------------------------------

>To UNSUBSCRIBE send: unsubscribe flasher in the body of an

>

email to list-managershocker [dot] com. Problems to: ownershocker [dot] com

>N.B. Email address must be the same as the one you used to subscribe.

>

For info on digest mode send: info flasher to list-managershocker [dot] com

> 

--------------

Byron Canfield, Canfield Studios (http://www.byronc.com)

President, Seattle Coreldraw Artists Network (http://www.corelsea.org)


------------------------------------------------------------------------

To UNSUBSCRIBE send: unsubscribe flasher in the body of an

email to

list-managershocker [dot] com

.  Problems to:

ownershocker [dot] com

N.B. Email address must be the same as the one you used to subscribe.

For info on digest mode send: info flasher to

list-managershocker [dot] com