FLASH: Reducing nodes

[P�terffy �ron]

Hi, I've some scanned, then traced graphics. My problem is, that the even

with fine-tuning the tracer, it creates a lot of nodes (points, etc.). In

Corel I can use Auto-Reduce, and it's OK - but I have to ungroup the object,

and reduce the nodes by shapes... and that's a bit time consuming. (Even not

as bad as modifying the nodes one-by-one)

Can Illustrator / Freehand / StreamLine do the same? Maybe with a few click

(on the object)?



                                            Thanx,



                                                    Aaron



flasher is generously supported by...

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

     flashforward2000 and The Flash Film Festival

  "The World�s Premier Flash Solutions Conference and Expo"

 March 27-29, Nob Hill Masonic Center, San Francisco, California


-Register before Feb 25 and save $200!!-- www.flashforward2000.com

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

To unsubscribe or change your list settings go to

http://www.chinwag.com/flasher or email

helpchinwag [dot] com