Re: FLASH: goto next scene in a loaded movie

[Cheri Harder]

Hi, Ryan:


Hard to know what you might have wrong without seeing it, but remember this:

when your movie is published, it is all flattened into one scene.  This

means it is easier to control your movie if you use labels for your frames;

then you can target your actions to a specific frame, by label.


Also, if you have wrapped your movie in a container movie (you've made it a

movie clip?  Or doing a "load movie?") then your paths may very well be your

problem, but we can't tell what they should be without more info.  Check out

http://www.flashbible.com/members/TellTarget/

for great info on tell-target paths.


(There's also a pretty good article on using movie clips as scenes, at

http://www.flashbible.com/members/MovieClips/AsScenes.htm)


HTH


~~~~Cheri Harder~~~~~

charderawsolution [dot] com

Advantage Web Solution

www.awsolution.com


> I've got a fairly complex animation, 29 scenes total, with a nav at the

> bottom that stops, starts, and a go to next scene button.  All of this

gets

> loaded in another movie.  The problem is this: I can't seem to get a the

> skip (goto next scene) button working.  When I run the animation by itself

> it works fine, but when it's loaded into the shell movie it no longer

works.

>

> I've tried goto next frame and tell target goto next frame

> but i'm afraid may paths are screwed up.




flasher is generously supported by...

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

     flashforward2000 and The Flash Film Festival

  "The World�s Premier Flash Solutions Conference and Expo"

 March 27-29, Nob Hill Masonic Center, San Francisco, California


-Register before Feb 25 and save $200!!-- www.flashforward2000.com

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

To unsubscribe or change your list settings go to

http://www.chinwag.com/flasher or email

helpchinwag [dot] com