FLASH: Tell Target + Fonts

[mantruc.com]

Hi flashers:


this is my first note to this list, i only subscribed yesterday....


1) I'm designing an interface in which each button (on roll over)

displays a movie clip, using tell target command.

the first design i did worked ok, though the move didn't show

in the parameters window, or the labeled frames in the labels

pull-down (actions pannel), it worked anyway.

then i tried to do the same trick in a new design, but the movie clip

wasn't recognized in the actions pannel, and it's not working.


What is it i'm doing wrong?


2)Newbie Q:  what about fonts, are fonts in flash machinde

dependable like in HTML?


thanks in advance


--

Javier Velasco M.          Comunicador Social

              --------------------

mantruc comunicaci�n           Desarrollo Web

                                  Dise�o Gr�fico

http://mantruc.com               Fotograf�a

              --------------------

http://evolt.org   Workers of the Web, evolt!





flasher is generously supported by...

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  Streaming Media WEST '99 Conference & Exhibition

  "The Worlds largest Internet Audio & Video Event"

 December 7 - 9, San Jose Convention Center, California


Reserve your space today at http://www.streamingmedia.com

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  To unsubscribe or change your list settings go to

http://www.chinwag.com/flasher or email

helpchinwag [dot] com