Re: FLASH: Tell Target + Fonts

[Rose Stipati]

Hi Javier,


> > 1) I'm designing an interface in which each button

> (on roll over)

> > displays a movie clip, using tell target command.

> > the first design i did worked ok, though the move

> didn't show

> > in the parameters window, or the labeled frames in

> the labels

Did you give each instance of the movie clip an

Instance Name? Macromedia has a pretty good

description of the procedure at:

http://www.macromedia.com/support/flash/ts/documents/tell_target.htm


Good luck,

Rose

rstipatiyahoo [dot] com

=====

Rose Stipati

rosestipatiyahoo [dot] com

rstipatiearthlink [dot] net

__________________________________________________

Do You Yahoo!?

Thousands of Stores.  Millions of Products.  All in one place.

Yahoo! Shopping: http://shopping.yahoo.com



flasher is generously supported by...

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  Streaming Media WEST '99 Conference & Exhibition

  "The Worlds largest Internet Audio & Video Event"

 December 7 - 9, San Jose Convention Center, California


Reserve your space today at http://www.streamingmedia.com

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  To unsubscribe or change your list settings go to

http://www.chinwag.com/flasher or email

helpchinwag [dot] com