Re: FLASH: tell target, load movie, if frame is loaded, scripting nightmare

[John Croteau]

Hi Christian,


> load the movie from level 1 into

> level 0 and thus clear out all other movies.

I'm not sure if you can load a Movie in one level then unload it and

load it again without delay into level 0. Plus there is no need.


> how can you check if a frame is loaded in a different movie.

> When I call up a tell target action, the if frame loaded option is

> greyed out.

You can only do a 'If Frame is Loaded' for the current movie. You can

however Tell Target a result to another Movie and/or Load or unLoad a

movie as one of the commands of an 'If Frame is Loaded".


The structure of the movie should be laid out at the beginning to

prevent major rework later.


-----------                               -----------------------

John Croteau

croteauerols [dot] com (mailto:croteauerols [dot] com)

-------------                             -------------------------

Flash Central(The Universe Starts Here) http://www.FlashCentral.com/

FlashTeK(Advanced Websites with Flash) http://www.CrownMall.com/Flash/

The Flash Tech Resource (Tech Notes)  http://www.FlashCentral.com/tech/

Need a PC ?  --  Computer King  --   http://www.crownmall.com/computers/

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~


------------------------------------------------------------------------

To UNSUBSCRIBE send: unsubscribe flasher in the body of an

email to

list-managershocker [dot] com

.  Problems to:

ownershocker [dot] com

N.B. Email address must be the same as the one you used to subscribe.

For info on digest mode send: info flasher to

list-managershocker [dot] com