Flasher Archive

[Previous] [Next] - [Index] [Thread Index] - [Previous in Thread] [Next in Thread]


Subject: Re: FLASH: Rotating Globe
From: Ashley Vail
Date: Sun, 14 Feb 1999 04:08:52 GMT

If the program in which you created the hollow globe allows, try exporting
the sequence in .ai format and importing into Flash. You should end up
with a file size of maybe 35kB.



At 05:40 PM 2/13/99 -0800, you wrote:
>Larry:
>
>I created the frames (30 of them) in RayDream Studio. I exported them as
>sequenced PICTs (I am on a Mac, and bmp is not compatable). To clarify,
>each original image is 40K, times 30 files imported into Flash total. For
>just those 30 frames, it came out to be over 200K for the .swf, which is
>way too long when you need to place it into a much longer movie (over 3
>minutes in length). I tried tracing and optimizing in Flash, but this only
>increase my file size by 4x. I didn't put the traced/optimized up to view,
>because it was over 800K and nobody is going to look at that! I hope this
>clarifys what my problem is.
>
>Thanks.
>
>Jayma
>
>>In a message dated 2/13/99 7:33:32 PM Eastern Standard Time,
>>jaymalandatearthlink [dot] net writes:
>>
>><< http://www.danaeweb.com/demos/jk/globe.html >>
>>i just opened it on ie4.0 aols browser even it took less than 20 seconds to
>>open which is long by some standard?
>>so when you sya you traced it it was a .bmp file originally or maybe more to
>>my point did this start in bryces or microsoft 3d and then get saved as a
>>.bmp? what is the file size of your original .bmp?
>>Larry
>>
>>------------------------------------------------------------------------
>>To UNSUBSCRIBE send: unsubscribe flasher in the body of an
>>email to list-manageratshocker [dot] com. Problems to: owneratshocker [dot] com
>>N.B. Email address must be the same as the one you used to subscribe.
>>For info on digest mode send: info flasher to list-manageratshocker [dot] com
>
>
>
>
>------------------------------------------------------------------------
>To UNSUBSCRIBE send: unsubscribe flasher in the body of an
>email to list-manageratshocker [dot] com. Problems to: owneratshocker [dot] com
>N.B. Email address must be the same as the one you used to subscribe.
>For info on digest mode send: info flasher to list-manageratshocker [dot] com
>
>
>

------------------------------------------------------------------------
To UNSUBSCRIBE send: unsubscribe flasher in the body of an
email to list-manageratshocker [dot] com. Problems to: owneratshocker [dot] com
N.B. Email address must be the same as the one you used to subscribe.
For info on digest mode send: info flasher to list-manageratshocker [dot] com

[Previous] [Next] - [Index] [Thread Index] - [Next in Thread] [Previous in Thread]