Re: FLASH: tell target

[WebFeat: Gavin Frayne]

>>Has anybody else noticed that you can't stop a movie clip using 'goto and

>>stop' in tell target and then start it again. The only way you can stop

and

>>start is with the basic commands. If I tell a movie to go frame x on

rollout

>>and then play and on a different event (rollover) it must change to

another

>>frame and stop, I it won't respond to either events. Is there a way around

>>this (seperate movie clips perhaps?) or am I doing something wrong?

>>

>

>You could just set the movie up so you have 'Actions' set in the movie to

>stop at a certain frames rather than a 'Mouseover' telling it to stop at a

>frame.



You can stop the movie using a stop action in a frame but then you have no

more control and the button stops responding to any events. Using a rollover

stop action, at least you can start it again. I'm confused.


Gavin



------------------------------------------------------------------------

To UNSUBSCRIBE send: unsubscribe flasher in the body of an

email to

list-managershocker [dot] com

.  Problems to:

ownershocker [dot] com

N.B. Email address must be the same as the one you used to subscribe.

For info on digest mode send: info flasher to

list-managershocker [dot] com