Flasher Archive
[Previous] [Next] - [Index] [Thread Index] - [Previous in Thread] [Next in Thread]
Subject: | FLASH: variable/go to problems |
From: | Olga |
Date: | Thu, 9 Mar 2000 05:16:58 GMT |
Is there any reason that the following would cause a movie to go to
"framelabel1" regardless of the value that "variable" contains?
i.e. variable = "" then movie goes to framelabel1 or if variable
="valuestuff" the movie also goes to framelabel1.
On (Release)
If (variable= "")
Go to and Play ("framelabel1")
End If
End On
thanks!
olga
olgatwitchy [dot] com
flasher is generously supported by...
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
flashforward2000 and The Flash Film Festival
"The World�s Premier Flash Solutions Conference and Expo"
March 27-29, Nob Hill Masonic Center, San Francisco, California
-Register before Feb 25 and save $200!!-- www.flashforward2000.com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
To unsubscribe or change your list settings go to
http://www.chinwag.com/flasher or email helpchinwag [dot] com
Replies
Re: FLASH: variable/go to problems, Branden Hall
[Previous] [Next] - [Index] [Thread Index] - [Next in Thread] [Previous in Thread]