Flasher Archive
[Previous] [Next] - [Index] [Thread Index] - [Previous in Thread] [Next in Thread]
Subject: | Using Onload to determine loading order |
From: | Andrew Ayres |
Date: | Sat, 23 May 1998 16:49:38 +0100 |
hi again,
Thanks a lot John for pointing out the solution I need. I'm now scouring
the Web (tried the Flash tech resource) and newgroups for an example of how
to use the Javascript onload command in this way (I'm a non-programmer!)
If anyone can point out a good link, or give example code, it'd help me.
cheers, Andrew
At 03:58 PM 5/22/98 -0400, you wrote:
>For Flash 2 JavaScript must be enabled:
>Load a blank or Static logo in the right frame.
>Replace the contents of the right frame with the Spaghetti using onLoad
>in frameset. onLoad in the frameset will not execute until all the
>frames are loaded. In your case the left and right(a temporary blank or
>Logo page).
>John Croteau croteauerols [dot] com (mailto:croteauerols [dot] com)
------------------------------------------------------------------------
To UNSUBSCRIBE send: unsubscribe flasher in the body of an
email to list-managershocker [dot] com. Problems to: ownershocker [dot] com
N.B. Email address must be the same as the one you used to subscribe.
For info on digest mode send: info flasher to list-managershocker [dot] com
Replies
Re: Using Onload to determine loading or, Jason Nugent
Re: Using Onload to determine loading or, Jason Nugent
Pointless Fluff ..., Tracy
the museum....., Jim Curry
Replies
Flash 3, Rico Reitz
2 flash movies - Loading order problem, , Andrew Ayres
Re: 2 flash movies - Loading order probl, John Croteau
[Previous] [Next] - [Index] [Thread Index] - [Next in Thread] [Previous in Thread]