Flasher Archive
[Previous] [Next] - [Index] [Thread Index] - [Previous in Thread] [Next in Thread]
Subject: | RE: FLASH: calculating angles |
From: | Verhaegen Tom |
Date: | Fri, 19 May 2000 12:38:03 +0100 |
Hi,
You need to get into the Cosinus and Sinus.
This is the only way to set up the angle, I cannot give you more info
because i have never used it, but i'm sure it works.
Tom Verhaegen
--
GUI Engineer
tom [dot] verhaegencarels [dot] com <tom [dot] verhaegencarels [dot] com (mailto:tom [dot] verhaegencarels [dot] com)>
--
Carels innovative Software
Derbystraat 33
9051 Ghent
Belgium
--
tel.+32(0)9 222 99 88
-----Original Message-----
From: ownerchinwag [dot] com [ownerchinwag [dot] com]On">mailto:ownerchinwag [dot] com]On Behalf Of Steve
"Leo" Leone
Sent: Thursday, May 18, 2000 9:07 PM
To: flasherchinwag [dot] com
Subject: FLASH: calculating angles
I'm trying to do the trigonometry to calculate and set the angle of a line
based on two sets of coords in a flash movie. I am tracking the width,
height, starting coords, and ending coords, but my trig's very rusty. Can
anyone lend a hand or point me in the right direction? Thanks in advance.
Leo
flasher is generously supported by...
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Get the last 100 messages from the flasher list NOW
http://www.chinwag.com/flasher/last100.shtml
Flash books http://www.chinwag.com/flasher/books.shtml
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
To unsubscribe or change your list settings go to
http://www.chinwag.com/flasher or email helpchinwag [dot] com
[Previous] [Next] - [Index] [Thread Index] - [Next in Thread] [Previous in Thread]