Flasher Archive
[Previous] [Next] - [Index] [Thread Index] - [Previous in Thread] [Next in Thread]
Subject: | Re: FLASH: cost of empty frames |
From: | Erik 'Gearik' Mattheis |
Date: | Tue, 10 Nov 1998 21:34:39 +0000 (GMT) |
Try adding 17 more layers (or however many you end up needing), make a
motion guide for each, then delete the new layers ... stagger comments
below the frame with the TT actions in them. They won't be exported with
the movie.
>What is the cost of a blank frame in a movie clip that is empty except for
>tell target instructions? Adding blank frames between groups of control
>instructions vastly improves the readability of the control because you can
>see the frame labels. But what is the cost to do this? I currently have 17
>control frames which expand to sixty-five when I add the spaces between the
>groups.
____________________________________________________________
Erik "Gearik " Mattheis
http://www.gourmandizer.com/
------------------------------------------------------------------------
To UNSUBSCRIBE send: unsubscribe flasher in the body of an
email to list-managershocker [dot] com. Problems to: ownershocker [dot] com
N.B. Email address must be the same as the one you used to subscribe.
For info on digest mode send: info flasher to list-managershocker [dot] com
Replies
RE: FLASH: cost of empty frames, Len Harrison
RE: FLASH: cost of empty frames, Len Harrison
Replies
FLASH: cost of empty frames, Len Harrison
[Previous] [Next] - [Index] [Thread Index] - [Next in Thread] [Previous in Thread]