Re: FLASH: Refering to a frame label from a different movie clip symbol

[Joseph Troha]

Apply an instance name to each MC and then Use tell target to target each MC

to "goto a frame".




Mike Chambers wrote:


> OK I have a flash movie with four frames.

>

> Each frame contains a movie clip symbol (each of which contains a number of

> frames). At the end of each movie clip symbol I have a button. When pressed

> I want the next movie clip to run. However, I cant figure out how to do

> this. I would normally use the following:

>

> On (Release)

>       Go to and Play ("frame label name here")

> End On

>

> However, this wont work because it tries to find that frame label name

> within the current movie clip... i have tried all of the following:

>

> /frame_label_name

> ../frame_label_name

> _level0/frame_label_name

>

> none of which have worked.

>

> I am getting pretty frustrated. Any help or suggestions would be

> appreciated...

>

> Mike C

>

>

meshex-pressnet [dot] com

>

> ------------------------------------------------------------------------

> To UNSUBSCRIBE send: unsubscribe flasher in the body of an

>

email to list-managerchinwag [dot] com. Problems to: helpchinwag [dot] com

> N.B. Email address must be the same as the one you used to subscribe.

>

For info on digest mode send: info flasher to list-managerchinwag [dot] com

--

Joseph Troha

Creative Factory

Level 3, 30 Inkerman Street

StKilda, Melbourne, Australia

v> +61 3 9593 8882

joecreativefactory [dot] com [dot] au

www.creativefactory.com.au




------------------------------------------------------------------------

To UNSUBSCRIBE send: unsubscribe flasher in the body of an

email to

list-managerchinwag [dot] com

.  Problems to:

helpchinwag [dot] com

N.B. Email address must be the same as the one you used to subscribe.

For info on digest mode send: info flasher to

list-managerchinwag [dot] com