FLASH: sound looping

[Kenneth Austin]

this is somewhat hard to explain, but here it goes

i am curious as to whether it's possible for one sound loop to precisely

follow another after a certain amount of loops


it is a 1 bar techno loop that changes to another loop after 8 bars, the

problem is that i am just eyeing where the waveform ends (in the frames),

then placing the next loop directly after.  sometimes it will match, but

sometimes it won't, especially after i upload it.  even with a preloader,

sometimes the framerate will change, offsetting the second loop


is there another way to do it?



i hope that wasn't too confusing



kenneth.c.austin

ovumdesign




flasher is generously supported by...

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Streaming Media WEST '99 Conference & Exhibition

"The Worlds largest Internet Audio & Video Event"

December 7 - 9, San Jose Convention Center, California


Reserve your space today at http://www.streamingmedia.com

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

To unsubscribe or change your list settings go to

http://www.chinwag.com/flasher or email

helpchinwag [dot] com