FLASH: tell target

[WebFeat: Gavin Frayne]

Has anybody else noticed that you can't stop a movie clip using 'goto and

stop' in tell target and then start it again. The only way you can stop and

start is with the basic commands. If I tell a movie to go frame x on rollout

and then play and on a different event (rollover) it must change to another

frame and stop, I it won't respond to either events. Is there a way around

this (seperate movie clips perhaps?) or am I doing something wrong?


TIA


Regards

Gavin



------------------------------------------------------------------------

To UNSUBSCRIBE send: unsubscribe flasher in the body of an

email to

list-managershocker [dot] com

.  Problems to:

ownershocker [dot] com

N.B. Email address must be the same as the one you used to subscribe.

For info on digest mode send: info flasher to

list-managershocker [dot] com