Re: FLASH: tell target

[Dixon]

>Has anybody else noticed that you can't stop a movie clip using 'goto and

>stop' in tell target and then start it again. The only way you can stop and

>start is with the basic commands. If I tell a movie to go frame x on rollout

>and then play and on a different event (rollover) it must change to another

>frame and stop, I it won't respond to either events. Is there a way around

>this (seperate movie clips perhaps?) or am I doing something wrong?

>


You could just set the movie up so you have 'Actions' set in the movie to

stop at a certain frames rather than a 'Mouseover' telling it to stop at a

frame.


Does this help


James Ede

Designer Type Bloke


Sky Rock Network	.....

Waterside Studios	.....

Bristol			.....

UK			.....

Jimmerskyrock [dot] co [dot] uk

 	.....


http://www.skyrock.co.uk





------------------------------------------------------------------------

To UNSUBSCRIBE send: unsubscribe flasher in the body of an

email to

list-managershocker [dot] com

.  Problems to:

ownershocker [dot] com

N.B. Email address must be the same as the one you used to subscribe.

For info on digest mode send: info flasher to

list-managershocker [dot] com