Re: FLASH: Movie Clips and Sound HELP!

[Jayma]

Hi Marc:


>At 07:52 PM 3/19/99 -0800, you wrote:

>>Ok, I am bringing this to you as a last resort.

>>

>>I am trying to make sound cues.

>>

>>I have a movie clip that is playing the ocean and seagulls in the first

>>part of the movie.  I have it set to loop until the visitor clicks on the

>>entry point.  You then move in to the point you clicked on, and as it fades

>>out, another image fades in behind it.

>

>Have you tried a fade-in on the second sound? that way, you could start it

>before ending the first sound.  Not sure from your description if this is

>helpful.



Yeah, I tried fading it in, and actually it wouldn't bother me if it played over the first sound, as it is very similar, yet much lower in volume.  But the problem is when I have the tell target to stop all sounds directed at the first clip, if the 2nd clip is playing, it stops it's sounds too.


I tried to just do a stop on the first clip, but that didn't stop the sound.


Ideally, I would like to have one movie clip fade into the other one, but since it is not a timed thing, but instead dependent on the user, I am just not sure this can be done.


Thanks.


------------------------------------------------------------------------ To UNSUBSCRIBE send: unsubscribe flasher in the body of an email to

list-managershocker [dot] com

.  Problems to:

ownershocker [dot] com

 N.B. Email address must be the same as the one you used to subscribe. For info on digest mode send: info flasher to

list-managershocker [dot] com